Trouble Shooting & Maintenance - Exerpeutic 1318 Owner's Manual

TROUBLE SHOOTING &MAINTENANCE
TROUBLE SHOOTING
PROBLEM: The elliptical wobbles when in use.
SOLUTION: Turn the rear stabilizer end cap on the rear stabilizer as needed to
level the elliptical.
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the computer console and verify the wires that come from the
computer console are properly connected to the wires that come from the front
post.
PROBLEM: There is no heart rate reading or there is erratic / inconsistent reading.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are
secure.
SOLUTION: To ensure the pulse readout is more precise, always hold on to the
handlebar grip sensors with two hands instead of just with one hand only.
SOLUTION: Avoid gripping the hand pulse sensors too tight. Try to maintain
moderate pressure while holding onto the hand pulse sensors.
PROBLEM: The elliptical makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the elliptical. Please inspect all of the
bolts and tighten any loose bolts.
MAINTENANCE
Cleaning
The elliptical can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the
elliptical after each use. Be careful not get excessive moisture on the computer
display panel as this might cause an electrical hazard or electronics to fail.
Please keep the elliptical, especially, the computer console out of direct sunlight
to prevent screen damage.
Please inspect all assembly bolts and pedals on the machine for proper tightness
every week.
Storage
Store the elliptical in a clean and dry environment away from children.
33