Trouble Shooting & Maintenance - Exerpeutic INDOOR TRAINING BIKE Owner's Manual

TROUBLE SHOOTING & MAINTENCE
TROUBLE SHOOTING
PROBLEM: The training bike wobbles when in use.
SOLUTION: Turn the adjustable leveler on the front and rear stabilizers as needed
to level the training bike.
PROBLEM: There is no display on the computer console.
SOLUTION: Verify the wire that comes from the computer console is properly
connected to the sensor wire.
SOLUTION: Check if the batteries are correctly positioned and battery springs are
in proper contact with batteries.
SOLUTION: The batteries in the computer console may be dead. Change to new
batteries.
PROBLEM: There is no heart rate reading or is erratic / inconsistent.
SOLUTION: Make sure that the hand pulse sensor wire is plugged into receptacle
located on the back of the computer.
SOLUTION: To ensure the pulse readout is more precise, always hold on to the
handlebar grip sensors with two hands instead of just with one hand.
SOLUTION: Gripping the hand pulse sensors too tight. Try to maintain moderate
pressure while holding onto the hand pulse sensors.
PROBLEM: The training bike makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the training bike, please inspect the bolts
and tighten the loose bolts.
MAINTENANCE
Cleaning
The training bike can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the
training bike after each use. Be careful not get excessive moisture on the
computer display panel as this might cause an electrical hazard or electronics to
fail.
Please keep the training bike, especially, the computer console, out of direct
sunlight to prevent screen damage.
Please inspect all assembly bolts and pedals on the machine for proper tightness
every week.
Storage
Store the bike in a clean and dry environment away from children.
20