Troubleshooting & Maintenance - Exerpeutic 5000 Owner's Manual

TROUBLESHOOTING & MAINTENANCE
TROUBLE SHOOTING
PROBLEM: The elliptical wobbles when in use.
SOLUTION: Turn the rear stabilizer end cap on the rear stabilizer as needed to
level the elliptical.
PROBLEM: There is no display on the console.
SOLUTION: Remove the console and verify the wires that come from the
console are properly connected to the wires that come from the front post.
PROBLEM: There is no heart rate reading or there is erratic / inconsistent
reading.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are
secure.
SOLUTION: To ensure the pulse readout is more precise, always hold on to the
handlebar grip sensors with two hands instead of just with one hand.
SOLUTION: Avoid gripping the hand pulse sensors too tight. Try to maintain
moderate pressure while holding onto the hand pulse sensors.
PROBLEM: The elliptical makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the elliptical. Please inspect all of the
bolts and tighten any loose bolts.
Correct
MAINTENANCE
Cleaning
The unit can be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents on plastic parts. Wipe your sweat off the unit after each use. Be careful not to
get excessive moisture on the console display panel, as this might cause an electrical
hazard or cause the electronics to fail. Keep the unit and the console out of direct
sunlight to prevent screen damage or premature wear. Inspect all assembly bolts and
pedals on the machine for proper tightness every week.
Storage
Store the unit in a clean and dry environment away from pets and children.
Incorrect
33
Before connecting
any cables, please
make sure the metal
prongs of the cable
are not damaged.