Troubleshooting & Maintenance - Exerpeutic 710ST Owner's Manual

TROUBLESHOOTING & MAINTENANCE
TROUBLESHOOTING
PROBLEM: The elliptical wobbles when in use.
SOLUTION: Turn the Rear Stabilizer End Cap (44) on the Rear Stabilizer (8) as needed to level
the elliptical.
PROBLEM: The Console (53) does not turn on.
SOLUTION: Remove the Console (53) and verify that ALL wires that come from the
Console (53) are properly connected to the wires that come from the Front Post (5).
PROBLEM: There is no Pulse reading or there is erratic / inconsistent readings.
SOLUTION: Make sure that the Lower Hand Pulse Wires (56) are securely connected to the
Upper Hand Pulse Wires (99).
SOLUTION: To ensure the pulse readout is more precise, always hold on to the
Hand Pulse Sensors (102) with two hands instead of just one.
SOLUTION: Avoid gripping the Hand Pulse Sensors (102) too tight. Try to maintain moderate
pressure while holding onto the Hand Pulse Sensors (102).
PROBLEM: The elliptical makes a squeaking noise when in use.
SOLUTION: Bolts may be loose on the elliptical. Inspect all bolts and tighten any that have become
loose over time.
MAINTENANCE
Cleaning
1. The elliptical can be cleaned with a soft cloth and mild detergent. Do not use abrasives or solvents
on plastic parts.
2. Wipe your perspiration off the elliptical after each use.
3. Be careful not get excessive moisture on the Console (53) as this might cause an electrical hazard
or electronics to fail.
4. Keep the elliptical, especially, the Console (53) out of direct sunlight to prevent screen damage.
5. Inspect all assembly bolts, nuts, and Screws on the machine for proper tightness every week.
Storage
Store the elliptical in doors and in a clean and dry environment away from children.
28