To Remove The Front Bezel - HP 53132A Assembly And Service Manual

225 mhz counter
Hide thumbs Also See for 53132A:
Table of Contents

Advertisement

Chapter 3 Replacing Assemblies

To Remove the Front Bezel

To Remove the Front Bezel
1
Remove the cover.
See the section titled "To Remove the Cover" in this chapter.
2
Remove the bail handle (MP7) by rotating it to the vertical
position and pull the ends outward as shown in Figure 3-3.
Figure 3-3. Handle Removal
3
Remove the front rubber bumper (part of MP2), stretch a corner
and then slide it off as shown in Figure 3-4.
Figure 3-4. Front Rubber Bumper Removal
4
Disconnect the front bezel flat-ribbon cable (which is actually
A2 Display Board's cable) from J6 of A1 Motherboard Assembly as
shown in Figure 3-5.
3-6
Assembly-Level Service Guide

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

53181a53131a

Table of Contents