To Remove The Cover - HP 53132A Assembly And Service Manual

WARNING
1
2
Chapter 3 Replacing Assemblies

To Remove the Cover

To Remove the Cover
The following steps are for removing the cover. The cover is removed to
access the board and cable assemblies, and all other internal parts.
WHEN THE COVER IS REMOVED FROM THE INSTRUMENT,
LINE VOLTAGES ARE EXPOSED WHICH ARE DANGEROUS AND
MAY CAUSE SERIOUS INJURY IF TOUCHED. DISCONNECT
POWER.
Turn off the Counter and remove power cord.
To remove the rear bezel, loosen the captive screws on the sides
as shown in Figure 3-1 using the TORX 15 screwdriver.
WARNING:
1
I
N
P
U
T
Ext
S
Arm
WARNING:
Figure 3-1. Rear Bezel Removal
3-4
NO OPERATOR SERVICEABLE PARTS INSIDE, REFER SERVICING TO SERVICE TRAINED PERSONNEL.
AC LINE:
2
ISM 1-A
92
FOR LABORATORY USE BY
QUALIFIED PERSONNEL
FOUR USAGE EN LABORATOIRE
PAR PERSONNEL QUALIFIE
3
OPTIONS
001 MS Oven 010 HS Oven
!
HP-IB
Talk Only
Ref
10 MHz Out To Configure:
In
Hold Recall during turn-on.
FOR CONTINUED FIRE PROTECTION, USE SPECIFIED ˜ LINE FUSE.
Assembly-Level Service Guide
RS - 232
Osc Adjust