Xerox Phaser 3450 Service Manual page 60

6.1.2.4 Solenoid & Clutch Test
- These Functions are used to check the present state (normal or not) of the solenoids and clutches.
1. Press the "Menu Key", until finding "Solenoid Test" is displayed on the panel.
2. Press the "Select Key", when it's found.
3. Press the "Arrow keys" (< / >), until finding the desired function.
(Refer to the table below)
4. Press the "Cancel Key", when it's found.
5. Press the "Select Key" for execution
Sub Menu
Tray1 Solenoid Test The tray1 solenoid is on for 150ms and then it automatically stops,
when the execution is chosen.
Tray2 Solenoid Test The tray2 solenoid is on for 150ms and then it automatically stops,
when the execution is chosen.
Tray3 Solenoid Test The tray3 solenoid is on for 150ms and then it automatically stops,
when the execution is chosen.
Tray2 Clutch Test The tray2 clutch is on for 1sec and then it automatically stops,
when the execution is chosen.
On this function, the main motor runs before 2sec from the point
of the clutch on in order to check the clutch state.
Tray3 Clutch Test The tray3 clutch is on for 1sec and then it automatically stops,
when the execution is chosen.
On this mode, the tray 3 motor runs before 2sec from the point
of the clutch on in order to check the clutch state.
--> When a tray 3 is not installed, this function is not processed
Description
and "Tray 3 Not Installed" is shown.
Alignment & Adjustments
Remarks
Tray 1 Solenoid On/Off
Tray 2 Solenoid On/Off
Tray 3 Solenoid On/Off
Tray 2 Clutch On/Off
Tray 3 Clutch On/Of
Service Manual
6-5