Remote Cable And Housing Installation - Rtr Only; Parts, Tools, And Supplies - SRAM RockShox Super Deluxe Service Manual

R e m o t e C a b l e a n d H o u s i n g I n s t a l l a t i o n - R T R O n l y
To install new cable and housing into the OneLoc™ remote, consult the OneLoc Remote User Manual on
P a r t s , T o o l s , a n d S u p p l i e s
Parts
• AM SVC kit 200h/1yr SDLX RMT A1
• RMT Spring kit DLX/SDLX/SDLXC
• Shift cable and housing
Safety and Protection Supplies
• Safety glasses
• Nitrile gloves
After the housing has been routed and installed on the bicycle, thread
1
the threaded ferrule onto the housing.
Do not push the housing into the threaded ferrule.
Install the threaded ferrule and housing into the cable hanger, then
2
tighten the ferrule lock screw until it is flush with the cable hanger.
Thread the cable through the housing, spool, and under the cable
3
spool bolt. Pull the cable tight and tighten the cable set screw to
0.9 N·m (7 in-lb).
www.sram.com/service.
Common Tools
• 2 and 3 mm hex wrenches
• 2 and 3 mm hex bit sockets
• 5 mm open end wrench
• Torque wrench
• Cable and Housing Cutters
5 mm

Remote Cable and Housing Installation - RTR Only

2 mm
2 mm 0.9 N·m (8 in-lb)
55