Pci Mezzanine Card Slots; Mvme6100 Installation And Use (V6100A/Ih2) - Motorola MVME6100 Installation And User Manual

COM1 is an RS232 port and the TTL- level signals are routed through appropriate EIA-232
drivers and receivers to an RJ-45 connector on the front panel. Unused control inputs on COM1
and COM2 are wired active. The reference clock frequency for the QUART is 1.8432 MHz. All
UART ports are capable of signaling at up to 115 Kbaud.

PCI Mezzanine Card Slots

The MVME6100 board supports two PMC slots. Two sets of four EIA-E700 AAAB connectors
are located on the MVME6100 board to interface to the 32-bit/64-bit IEEE P1386.1 PMC to add
any desirable function. The PMC slots are PCI/PCI-X 33/66/100 capable.
PMC/IPMC slot 1 supports:
Mezzanine Type:
Mezzanine Size:
PMC Connectors:
Signaling Voltage:
PMC slot 2 supports:
Mezzanine Type:
Mezzanine Size:
PMC Connectors:
Signalling Voltage:
Note You cannot use 3.3V and 5V PMCs together; the voltage keying pin on slots 1 and 2 must
be identical. When in 5V mode, the bus runs at 33 MHz.
In addition, the PMC connectors are located such that a double-width PMC may be installed in
place of the two single-width PMCs.
In this case, the MVME6100 supports:
Mezzanine Type:
Mezzanine Size:
PMC Connectors:
Signaling Voltage:
PMC/IPMC = PCI Mezzanine Card
S1B = Single width and standard depth
(75mm x 150mm) with front panel
J11, J12, J13, and J14 (32/64-bit PCI with front and
rear I/O)
VIO = +3.3V (+5V tolerant) or +5V, selected by keying
pin
PMC = PCI Mezzanine Card
S1B = Single width and standard depth
(75mm x 150mm) with front panel
J21, J22, J23, and J24 (32/64-bit PCI with front and
rear I/O)
VIO = +3.3V (+5V tolerant) or +5V, selected by keying
pin
PMC = PCI Mezzanine Card
Double width and standard depth
(150mm x 150mm) with front panel
J11, J12, J13, J14, J21, J22, J23, and J24
(32/64-bit PCI with front and rear I/O)
VIO = +3.3V (+5V tolerant) or +5V, selected by keying
pin

MVME6100 Installation and Use (V6100A/IH2)

Chapter 4 Functional Description
43