Boundary Scan Header (J8); Pmc/Ipmc Selection Headers (J10, J15 - J18, J25 - J28); Table 5-17. Boundary Scan Header (J8) Pin Assignments; Table 5-18. Pmc/Ipmc Configuration Jumper Block - Motorola MVME6100 Installation And User Manual

Chapter 5 Pin Assignments

Boundary Scan Header (J8)

The 14-pin boundary scan header provides an interface for programming the on-board PLDs
and for boundary scan testing/debug purposes. The pin assignments for this header are as
follows:

Table 5-17. Boundary Scan Header (J8) Pin Assignments

Pin Signal
1 TRST_L
3 TDO
5 TDI
7 TMS
9 TCLK
11 NC
13 AW_L
PMC/IPMC Selection Headers (J10, J15 – J18, J25 – J28)
Nine 3-pin 2 mm planar headers allow for PMC/IPMC I/O selection. These nine headers can
also be combined into one single header block where a block shunt can be used as a jumper.
The pin assignments for these connectors are as follows:

Table 5-18. PMC/IPMC Configuration Jumper Block

Pin/Row 1
(PMC I/O)
J28 PMC1_IO(2)
J16 PMC1_IO(5)
J18 PMC1_IO(8)
J25 PMC1_IO(11)
J27 PMC1_IO(14)
J26 PMC1_IO(17)
J17 PMC1_IO(20)
J10 PMC1_IO(23)
J15 PMC1_IO(26)
A jumper installed across pins 2 and 3 on all nine headers selects PMC1 I/O for IPMC mode.
64
MVME6100 Installation and Use (V6100A/IH2)
Signal
GND
GND
GND
GND
GND
CPU_BSCAN_L
GND
Pin/Row 2 Pin/Row 3
(P2 Pins) (IPMC Pins)
P2_PMC1_IO(2) IPMC DB8_L
P2_PMC1_IO(5) IPMC DB9_L
P2_PMC1_IO(8) IPMC DB10_L
P2_PMC1_IO(11) IPMC DB11_L
P2_PMC1_IO(14) IPMC DB12_L
P2_PMC1_IO(17) IPMC DB13_L
P2_PMC1_IO(20) IPMC DB14_L
P2_PMC1_IO(23) IPMC DB15_L
P2_PMC1_IO(26) IPMC DBP1_L
Pin
2
4
6
8
10
12
14