Interrupt Controller - Motorola MVME6100 Installation And User Manual

serial EEPROM following a reset and initialize any number of internal registers. In the second
function, the controller is used by the system software to read the contents of the VPD
EEPROM contained on the MVME6100 board, along with the SPD EEPROMs for on-board
memory to further initialize the memory controller and other interfaces.
The MVME6100 board contains the following I
■
8KB EEPROM for user-defined MV64360 initialization
■
8KB EEPROM for VPD
■
8KB EEPROM for user data
■
Two 256 byte EEPROMs for SPD
■
DS1621 temperature sensor
■
One 256 byte EEPROM for PMCspan PCIx-PCIx bridge use
The 8KB EEPROM devices are implemented using Atmel AT24C64A devices or similar parts.
These devices use two byte addressing to address the 8KB of the device.

Interrupt Controller

The MVME6100 uses the interrupt controller integrated into the MV64360 device to manage
the MV64360 internal interrupts as well as the external interrupt requests. The interrupts are
routed to the MV64360 MPP pins from on-board resources as shown in the MVME6100
Programmer's Guide. The external interrupt sources include the following:
■
On-board PCI device interrupts
■
PMC slot interrupts
■
VME interrupts
■
RTC interrupt
■
Watchdog timer interrupts
■
Abort switch interrupt
■
External UART interrupts
■
Ethernet PHY interrupts
■
IPMC761 interrupts
■
PMCspan interrupts
For additional details regarding the external interrupt assignments, refer to the MVME6100
Programmer's Guide.
Chapter 4 Functional Description
2
C serial devices:
MVME6100 Installation and Use (V6100A/IH2)
41