Microscan MS-1 Integration Manual page 5

Chapter 7
Chapter 8
Chapter 9
Appendices
MS-1 Scan Engine Integration Manual
Continuous Read 1 Output Emulation ..................................................... 6-9
Serial Trigger Character (Delimited) ...................................................... 6-10
Start Trigger Character (Non-Delimited)................................................ 6-11
Stop Trigger Character (Non-Delimited) ................................................ 6-12
No Decode Timeout............................................................................... 6-13
Decodes Before Output ......................................................................... 6-14
No Read Message ................................................................................. 6-15
Reader Setup ........................................................................................ 6-16
Symbologies
Symbologies by ESP ............................................................................... 7-2
Symbologies Serial Commands .............................................................. 7-3
Code 39 ................................................................................................... 7-4
Codabar ................................................................................................... 7-6
Interleaved 2 of 5 ..................................................................................... 7-8
Code 128/EAN-128 ............................................................................... 7-10
Code 93 ................................................................................................. 7-11
GS1 DataBar (RSS) .............................................................................. 7-12
MSI Code............................................................................................... 7-13
Plessey Code ........................................................................................ 7-14
Industrial 2 of 5 ...................................................................................... 7-15
UPC/EAN............................................................................................... 7-17
Symbology Identifier .............................................................................. 7-20
Terminal
Terminal Window ..................................................................................... 8-2
Find.......................................................................................................... 8-3
Send ........................................................................................................ 8-4
Macros..................................................................................................... 8-5
Terminal Window Menus ......................................................................... 8-6
Utilities
Serial Utility Commands .......................................................................... 9-2
Differences from Default .......................................................................... 9-3
Firmware.................................................................................................. 9-4
Device Control ......................................................................................... 9-9
Default/Reset/Save................................................................................ 9-10
Reader Status Request ......................................................................... 9-11
Appendix A General Specifications .........................................................A-2
Appendix B Electrical Specifications .......................................................A-5
Appendix C Serial Configuration Commands ..........................................A-6
Appendix D Communications Protocol ....................................................A-9
Appendix E ASCII Table ........................................................................A-10
Appendix F Using an External Trigger...................................................A-11
Appendix G Glossary of Terms .............................................................A-12
Introduction
v