Installing The Ts Adapter Unit On A Din Rail; Installing The Ts Adapter On A Panel - Siemens S7-1200 System Manual

Hide thumbs Also See for S7-1200:

Table of Contents

Installing the TS adapter unit on a DIN rail

Prerequisites: You must have connected the TS Adapter and a TS module together, and the

DIN rail must have been installed.

If you install the TS unit vertically or in high-vibration environment, the TS module can

become disconnected from the TS Adapter. Use an end bracket 8WA1 808 on the DIN rail to

ensure that the modules remain connected.

Installing and removing the TS Adapter

Safety requirements for installing or removing the TS Adapter.

Before you remove power from the unit, disconnect the grounding of the TS Adapter by

removing the analog cable and Ethernet cable. Failure to observe this precaution could

result in death, severe personal injury and/or property damage due to unexpected

equipment operation.

Always follow these requirements when installing or removing the TS Adapter.

Prerequisites: You must have connected the TS Adapter and TS module.

1. Move the attachment slider

2. Screw the TS Adapter and TS module to the position marked with

S7-1200 Programmable controller

System Manual, 03/2014, A5E02486680-AG

direction of the arrow until it engages.

assembly wall.

Installation:

1. Hook the TS Adapter with attached TS module

2. Rotate the unit back until it engages.

3. Push in the DIN rail clip on each module to attach each module to the

1. Remove the analog cable and Ethernet cable from the underside of

the TS Adapter.

2. Remove power from the TS Adapter.

3. Use a screwdriver to disengage the rail clips on both modules.

4. Rotate the unit upwards to remove the unit from the DIN rail.

to the backside of the TS Adapter and TS module in the

3.3 Installation and removal procedures

on the DIN rail

to the designated

Installation