Common Error Codes For The "Extended" Instructions - Siemens S7-1200 System Manual

Table 8- 184 Condition codes
RET_VAL Description
(W#16#...)
0000 No error
8090 Hardware identifier of the module at the LADDR parameter is invalid.
8.10

Common error codes for the "Extended" instructions

Table 8- 185 Common condition codes for the extended instructions
Condition code (W#16#....)
8x22
2
8x23
8x24
8x25
8x28
8x29
8x30
8x3A
If one of these errors occurs when a code block is executed, then the CPU remains in RUN (default) or can be
1
configured to go to STOP. Optionally, you can use the GetError or GetErorID instructions within that code block to
handle the error locally (CPU remains in RUN), and create a programmed reaction to the error.
The "x" represents the parameter number with the error. Parameter numbers start with 1.
2
S7-1200 Programmable controller
System Manual, 03/2014, A5E02486680-AG
Description
1
Area too small for input
Area too small for output
Illegal input area
Illegal output area
Illegal input bit assignment
Illegal output bit assignment
Output area is a read-only DB.
DB does not exist.
8.10 Common error codes for the "Extended" instructions
Extended instructions
407