Configuring The Local/Partner Connection Path Between Two Devices; Get/Put Connection Parameter Assignment - Siemens S7-1200 System Manual

Communication
10.5 S7 communication
Click the "Highlighted: Connection" button to access the "Properties" configuration dialog of
the communication instruction.
10.5.3

Configuring the Local/Partner connection path between two devices

Configuring General parameters
You specify the communication parameters in the "Properties" configuration dialog of the
communication instruction. This dialog appears near the bottom of the page whenever you
have selected any part of the instruction.
Refer to "Device configuration: Configuring the Local/Partner connection path (Page 150)"
for more information.
In the "Address Details" section of the Connection parameters dialog, you define the TSAPs
or ports to be used. The TSAP or port of a connection in the CPU is entered in the "Local
TSAP" field. The TSAP or port assigned for the connection in your partner CPU is entered
under the "Partner TSAP" field.
10.5.4

GET/PUT connection parameter assignment

The GET/PUT instructions connection parameter assignment is a user aid for configuring
CPU-to-CPU S7 communication connections.
After inserting a GET or PUT block, the GET/PUT instructions connection parameter
assignment is started:
592
S7-1200 Programmable controller
System Manual, 03/2014, A5E02486680-AG