Reset Module To Factory Settings - Siemens S7-1200 System Manual

Hide thumbs Also See for S7-1200:

Table of Contents

SM 1278 4xIO-Link Master

15.1 SM 1278 4xIO-Link Master overview

Reset module to factory settings

Effects of resetting to the factory settings

Use the function "Reset to factory settings" to restore the parameter assignments you made

with S7-PCT to the delivery state.

After a "Reset to factory settings", the parameters of the SM 1278 4xIO-Link module are

assigned as follows:

● The ports are in DI mode

● The ports are mapped to the relative addresses 0.0 to 0.3

● The PortQualifier is disabled

● Maintenance data 1 to 3 is deleted

When you reset to factory settings, the device parameters are deleted and the delivery state

is restored.

If you remove an SM 1278 4xIO-Link signal module, reset it to factory settings before you put

it into storage.

For "Reset to factory settings", proceed as described in the S7-PCT online help under

"Master Configuration > 'Commands' tab".

S7-1200 Programmable controller

System Manual, 03/2014, A5E02486680-AG