Emerson SI-DeviceNet User Manual page 71

12.1.4 SI-DeviceNet network diagnostic
The operating status of the SI-DeviceNet module can be viewed in the network
diagnostic parameter (Pr S.01.006). All possible values of this parameter are described
in Table 12.4.
Table 12.4 SI-DeviceNet network operating status
Value
0
1
2
3
4
5
6
7
SI-DeviceNet User Guide
Issue Number: 2
Text
Network OK Network ok/healthy
The SI-DeviceNet has initialized correctly and is waiting
Init OK
for the DeviceNet master to initialize communications.
No cyclic data has been recognized. This could be due to
No Cyclic the length of the mapping data is not equal to the master
setup.
A part of the SI-DeviceNet initialization sequence was not
Init Failed successful. If this fault persists after a power-cycle,
replace the SI-DeviceNet.
Fault found in the communications of the module. This
Comm Fault could be due to different devices being configured to use
different baud rates.
No 24 V No 24 V external PSU has been detected.
Baud detecting Automatic baud rate detection is in progress.
Initializing The module is currently initializing.
Description
71