Emerson SI-DeviceNet User Manual page 36

The mapping error codes are described in the table below:
Value
0
1
2
3
4
5
6
7
8
9
10
Input processing time
S.01.024
Output processing time
S.01.025
Pr S.01.024 and Pr S.01.025 display the input and output processing times respectively.
The input processing time (Pr S.01.024) shows the time taken from the value being sent
from the drive to the value being written to the master in milliseconds. The output
processing time (Pr S.01.025) shows the time taken from the value being sent from the
master to the value being successfully written to the drive in milliseconds.
36
Text
No error has been detected during mapping
No error
initialization.
Par impossible The parameter may not exist or may not be readable.
Hole in mapping Cyclic data mapping parameters are not contiguous.
Two or more cyclic data mapping configuration
Dup mapping parameters have been configured with the same
destination parameter reference.
The length of the mapped parameters exceeds the
Length exceed
length of the selected assembly object.
Obj not support The selected assembly object is not supported.
If the predefined object is selected, the data alignment
Pre & uncompress
must be set to 16 bits.
The IN and OUT objects both must be predefined
Type unmatched
objects, or neither.
Memory fault Failed to allocate memory for mapping.
No mapping No parameter is assigned to the mapping.
Reserved Reserved
Default
Range
Access
Default
Range
Access
N/A
0 to 65535 ms
RO
N/A
0 to 65535 ms
RO
Description
SI-DeviceNet User Guide
Issue Number: 2