Emerson SI-DeviceNet User Manual page 30

All possible values of S.01.006 are given in the table below.
Value
0
1
2
3
4
5
6
7
Network loss selection
S.01.010
The network loss detection feature provides a method which ensures that
communication with the master is still present. The SI-DeviceNet resets an internal
timer when a valid message is received from the DeviceNet network, if a message is not
received within the specified period, network loss is detected.
NOTE
Network loss detection is not enabled internally until cyclic data has been detected. This
prevents spurious network loss timeouts while the DeviceNet master controller is
initializing the DeviceNet network.
Timeout action
S.01.011
Pr S.01.011 determines the action to take when a timeout specified by Pr S.01.010
occurs. All possible actions and descriptions are listed below.
Value
0
1
2
3
4
30
Text
Network OK Network ok/healthy
The SI-DeviceNet has initialized correctly and is waiting
Init OK
for the DeviceNet master to initialize communications.
No cyclic data has been recognized. This could be due to
No Cyclic the length of the mapping data is not equal to the master
setup.
A part of the SI-DeviceNet initialization sequence was not
Init Failed successful. If this fault persists after a power-cycle,
replace the SI-DeviceNet.
Fault found in the communications of the module. This
Comm Fault could be due to different devices configured to use
different baud rates.
No 24 V No 24 V external PSU has been detected.
Baud detecting Automatic baud rate detection is in progress.
Initializing The module is currently initializing.
Default
Range
Access
Default
Range
Access
Text
Trip
Send flt values
Clear output
Hold last
No action
Description
200 ms
0 to 3000 ms
RO
Trip (0)
Trip (0) to No action (4)
RW
Trip the drive
Send fault values to output parameters
PLC output parameters will have values set to zero
Hold the last value in the PLC output parameters
No action with output parameters
Description
SI-DeviceNet User Guide
Issue Number: 2