System Settings Menu; Ports Menu - Lightware MMX8x8-HDMI-4K-A User Manual


  
4. Operation
4.3.1. System Settings Menu
Network Submenu
The parameters of the network connection
can be set in this submenu. IP, Subnet,
Gateway and MAC parameters show the
current settings. If the DHCP option is
disabled, three more parameters are listed
which can be set for a static IP address:
Static IP,
▪
Static Subnet,
▪
▪ Static Gateway.
ATTENTION! If you change the network settings, always press the
Save option under Network menu (not only in the submenu of the
parameter) to apply the new settings.
RS-232 Submenu
When entering the submenu the available
serial ports are listed. Select the desired port
and enter to see the settings.
Adjustable parameters of the serial ports:
Mode (Disconnect/ Control/
▪
Command injection),
Baud Rate* (4800/ 7200/ 9600/ 14400/
▪
19200/ 38400/ 57600/ 115200)
▪ Protocol (LW2/ LW3).
*At Mixed IR /TTL serial port, only this setting is available.
Front Panel Submenu
The following front panel-related parameters
can be set in this submenu:
Display Backlight (1-10)
▪
The brightness of the LCD can be set from 1
to 10 on a scale.
▪ Rotary Direction (CW Down/
CCW Down)
Device Info Submenu
In this submenu you can check basic
information about the transmitter unit:
NETWORK
▪ Serial number
> Current IP
Hardware Version
▪
192.168.0.101
▪ Firmware Version
Current Subnet
255.255.255.0
Save
« Back

Factory Defaults Submenu
Factory default settings will be restored by
choosing Yes.
Reset Device Submenu
RS232 1 There is a possibility to reset the device.
> Mode
Disconnect
Baud rate
57600
« Back
Bootload Mode Submenu
Special function for entering the bootload
mode.
DISPLAY BACKLIGHT
9 ☼
☼
0 2 4 6 8 10
MMX8x4-HT series – User's Manual
DEVICE INFO
> Serial Number
00005484
Hardware Version
V10_BAA0
« Back
FACTORY DEFAULTS
Are you sure you
want to proceed?
Yes
« No

RESET DEVICE
Are you sure you
want to reboot
the device?
Yes
« No

BOOTLOAD MODE
Are you sure you
want to enter
bootload mode?
Yes
« No

4.3.2. Ports Menu
When entering the menu the available video
input and output ports are listed. The icons
display information about the port and the
video signal (see below table). Select the
desired port and enter to see the submenu.
Grey White
Description
icon icon
Source/sink is not
 
connected
No audio signal in the
 
video stream
 
Signal is not present
Signal is not encrypted
 
with HDCP
 
The port is unmuted
Video Status Submenu for Input Ports
The most important properties of the chosen
input port can be checked in this submenu:
Parameter Input port
+5V present Present/ Not present
Signal Present Present/ Not present/Unknown
HDCP Status Encrypted/ Not encrypted/Unknown
Embedded Audio Present/ Not present/Unknown
Pixel Clock (MHz) No signal/ [x] MHz
Unknown/ No signal/
Active Resolution
[x]x[y][i\|p][f]
Unknown/ No signal/
Total Resolution
[x]x[y]
27
PORTS
> I1
I2
I3
I4
« Back
Description
Source/sink is
connected
Audio is embedded in
the video stream
Signal is present
Signal is encrypted
with HDCP
The port is muted
VIDEO STATUS
> +5V present
Present
Signal Present
Present
« Back