Hdmi And Tps Output Port Properties; Test Pattern Generator - No Sync Screen (Hdmiout, Tpsout) - Lightware MMX8x8-HDMI-4K-A User Manual


  
5. Software Control – Lightware Device Controller
5.5.4. HDMI and TPS Output Port Properties
INFO: MMX8x8-HDMI-4K-A model has no TPS output port.
TPS Output Port Properties Window
MMX8x4-HT series – User's Manual
Available Settings
▪ Port name
Mute/unmute the port;
▪
▪ Lock/unlock the port;
▪ Autoselect settings (Enabled / Disabled, Mode and Priorities) See
more details about this feature in The Autoselect Feature
Pay attention for the following settings for the proper operation
of Autoselect function:
– Set the Autoselect settings to Enabled;
– Be sure that no input is set to the same priority number;
– Be sure that all priority values are filled in (no empty space);
– Be sure that all inputs are enabled with the green checkbox
on the right side;
– Always click on the Set priorities button after the changes to
launch the new settings.
▪ Signal type (Auto / DVI / HDMI);
▪ HDCP mode (Auto / Always): The transmitter forces the source
sent the signal without encryption if the content allows when
▪ PWR5V mode (Auto / Always on / Always off): The setting lets
the source and the sink devices be connected – independently
from the transmitted signal;
TPS mode* (Auto / HDBaseT / LPPF1 in MMX8x4-HT400MC
▪
model and Auto / HDBaseT / Longreach / LPPF1 / LPPF2 in
MMX8x4-HT420M model). See more details about this setting
in section.
TPS Working Modes
▪ PoE setting* (enable / disable): The matrix is able to supply (send
remote power) devices through the TPS input and output ports
which are compatible with the PoE standard.
INFO: MMX8x4-HT400MC model does not support PoE.
▪ No sync screen: configuration settings of the test pattern. See
more details in the Test Pattern Generator - No Sync Screen
(HDMIOUT, TPSOUT) section.
▪ Frame Detector;
Cable Diagnostics (TPSIN, TPSOUT) *;
▪
▪ Reloading Factory Default Settings for the selected port
*TPS related settings can be found only in TPS output properties
window.
5.5.5. Test Pattern Generator - No Sync Screen (HDMIOUT, TPSOUT)
The output ports can send a special image towards the sink devices
for testing purposes.
The setting is available on output ports with the following parameters:
section.
Mode
On: the test pattern is always sent to the output port.
▪
▪ Off: the test pattern generator is off.
▪ No signal: the test pattern generator is switched on if no video
signal is switched to the given output port.
Clock source
480p / 576p / Original video signal: the clock frequency of the
▪
test pattern.
Pattern
▪ Red / Green / Blue / Black / White / Ramp / Chess / Bar / Cycle.
Cycle setting means all the patterns are changed sequentially
approx. in every 2 seconds.
ATTENTION! The Mode can be set individually on each port, but the
the Clock source and Pattern settings are the same on O1-O3 and
O2-O4 output ports.
38
Test patterns