Operation; Powering On; Status Leds; Front Panel Lcd Menu Operations - Lightware MMX8x8-HDMI-4K-A User Manual


  

4. Operation

4
O peration
This chapter is about the powering and operating of the device describing the
functions which are available by the front/rear controls:

Powering On

Ý

Status LEDs

Ý

Front Panel LCD Menu Operations

Ý
Front Panel Button Operations
Ý
Front Panel Operations – Quick Summary
Ý
MMX8x4-HT series – User's Manual
4.1. Powering On
Connect the power cord to the AC input connector; the matrix is
immediately powered on. After the self-test (about 30 seconds), the
last configuration is loaded automatically.
INFO: The router has an internal emergency memory that stores all
current settings and tie configurations. This memory is independent
from presets and invisible for the user. This built-in feature helps
the system to be ready immediately in case of power failure or
accidental power down.
4.2. Status LEDs
LIVE
blinking slow The unit is on and operates properly.
green
green blinking fast The unit is in bootload mode.
off The matrix is out of operation.
POWER
green on Power LED indicates that the unit is
powered on.
off The matrix unit is NOT powered or out
of operation.
48V*
on Phantom power is turned on.
red
off Phantom power is turned off.
MMX8x4-HT400MC and MMX8x4-HT420M models
TPS LEDs
Remote power (PoE) is inactive,
off
device is powered locally.
amber on Remote power is active.
No TPS link between the transmitter
off
and receiver.
Device is in low power mode or
green blinking
Ethernet fallback mode.
green on TPS signal is present.
4.3. Front Panel LCD Menu Operations
The front panel has a color LCD that shows the most important
settings and parameters structured in a menu. The jog dial control
knob can be used to navigate between the menu items or change the
value of a parameter. The knob can be pressed to enter a menu or
edit/set a parameter.
MAIN MENU
> System Settings
Ports
EDID
Health
Crosspoint
FRONT
Menu navigation
& change parameter
Turn
FRONT
Menu selection
& set parameter
Press
REAR
REAR
Parameter Selection
The blue colored line means the selected
menu/parameter, the green
current setting.
TIPS AND TRICKS: The faster you rotate
the jog dial, the faster the parameter list is
scrolled.
26
System Settings
Network
RS-232
Front panel
Device Info
Factory Defaults
Reset Device
Bootload Mode
Ports
I,O
Video Status
Video Settings
EDID
View
Switch
Save
Health
Operation
Temperatures
Voltages
Crosspoint
Switch
View
HDCP ENABLE
> Disabled
one means the
Enabled
« Back