Touch Pad - Lippert Components Ground Control 3.0 User Manual

Touch Pad

Note: To clear an error from the touch pad, repair or otherwise
correct the issue, then press "ENTER". If the error is still
present, the message will be displayed again.
LCD Message What's Happening?
Controller not properly secured.
****ERROR****
Excess Angle
Excessive angle reached during auto operation.
Controller not properly secured.
****ERROR****
Excessive angle reached during manual operation.
Excessive Angle
Front of trailer below level when starting Auto Level process
(only triggers when trying to initiate Hitch Recognition).
****ERROR****
Touch pad power not cycled between consecutive leveling
Feature Disabled
operations.
Zero point not set.
****ERROR****
Battery voltage dropped below 10.8V.
Low Voltage
Jack has reached maximum stroke length and is unable to
lift.
****ERROR****
Out Of Stroke
Unexpected high amp current stall.
****ERROR****
Bad connection or wiring from the controller to the rear
sensor.
External Sensor
****ERROR****
Time limit exceeded for the requested auto operation.
Jack Time Out
Unable to auto level due to uneven ground.
****ERROR****
Unable to auto level due to zero point being set incorrectly.
Auto Level Fail
****ERROR****
Communication between the controller and touch pad has
been lost.
Comm Error
****ERROR****
Sensor calibration values are out of range.
Bad Calibration
****ERROR****
Internal sensor problem.
Internal Sensor
**PANIC STOP** The user pressed a button on the touch pad during an
Function Aborted automatic operation.
***ERROR****
Short circuit detected in one of the hall effect circuits.
Hall Effect Short
lci1.com (574) 537-8900
Ground Control® 3.0
Aftermarket Manual
What Should Be Done?
Check and secure controller placement.
Relocate the trailer.
Check and secure controller placement.
Relocate the trailer.
Using manual mode on the touch pad, retract rear jacks (which
includes the middle, if equipped) and set landing gear (front jacks) to
hitch height.
Turn touch pad off and then back on to reset the system.
Set zero point.
Check wiring - repair or replace.
Test battery voltage under load - charge or replace.
Check disposition of jacks. Relocate the trailer.
Check jacks in manual mode or perform manual override procedure.
Repair or replace as needed.
Check for bent or damaged jacks. Repair or replace as needed.
Replace or repair connection to rear remote sensor.
Check disposition of jacks.
Check disposition of jacks. Relocate the trailer.
Reset zero point.
Check harness for proper connections or damage. Repair or replace
as needed.
Replace controller.
Replace controller.
Restart automatic operation and then refrain from pressing any buttons
on the touch pad.
Test for short. Repair or replace as needed.
18
CCD-0001307
Rev: 04.19.18