Installation - Controller - Lippert Components Ground Control 3.0 User Manual

Installation - Controller

Note: Prior to starting this portion of the installation, double
check that all of the harnesses are properly and securely
connected to the rear jacks, landing gear, and rear sensor.
Once those connections have been checked, reattach the
underbelly to the frame of the trailer in the same position
from which it was removed. If any tears are present in the
underbelly, seal with waterproof tape. Once the underbelly is
secured, the installation may be continued.
Fig.15
Note: The compartment where the controller will be installed
should be as far forward on the trailer as is possible and the
controller MUST be installed in compliance with RVIA Gas
Codes, as the controller connections are not spark-proof.
Note: For optimal performance, the controller should be
positioned directly in the center of the trailer, but may be offset
if necessary (Fig. 3A). The arrow on the label of the controller
MUST point to the front of the trailer (Fig. 15).
Note: Some 6-point controllers do not have orientation arrows
for the front of the trailer. When installing those controllers,
ensure that the port labeled "LEFT FRONT" is pointing to the
left-hand front of the trailer. This will ensure proper orientation
and function of the controller.
lci1.com
Fig. 15 Detail
(574) 537-8900
Ground Control® 3.0
Aftermarket Manual
1. Measure to the center of the trailer from inside the
compartment where the controller will be placed, and mark
the center point on the ceiling. The controller MUST be
positioned directly in the center of the trailer with the arrow on
the label of the controller facing the front of the trailer. (Fig.
15).
2. Using four #8 x 1" wood screws, attach the controller to
the ceiling of the compartment, centered over the marked
centerline in the compartment (Fig. 16).
3. Attach the power and ground harness to the corresponding
posts on the controller and then connect them to the correct
posts on the house battery.
4. Connect all jack harnesses to the appropriate connectors on
the controller.
Controller
(4 Point)
#8 x 1" Wood Screw
Fig.16
9
CCD-0001307
Compartment Ceiling
Rev: 04.19.18