Remote Control Via Usb - Rigol DS4024E User Manual

RIGOL

Remote Control via USB

1. Connect the device
Connect the oscilloscope (USB DEVICE interface) with your PC (USB HOST
interface) using a USB cable.
2. Install the USB driver
This oscilloscope is a USB-TMC device. After you connect the oscilloscope to the
PC and turn on the oscilloscope for the first time (the oscilloscope is
automatically configured to USB interface; at the same time, make sure that
Utility  IO Setting  USB Device is set to "Computer"), the Found New
Hardware Wizard dialog box as shown in the figure below is displayed on the
PC. Please install the "USB Test and Measurement Device (IVI)" driver following
the directions in the wizard. The steps are as follows.
14-2
Chapter 14 Remote Control
1
2
DS4000E User's Guide