Remote Control Via Lan - Rigol DS4024E User Manual

RIGOL

Remote Control via LAN

1. Connect the device
Connect the oscilloscope to your LAN using a network cable.
2. Configure the network parameters
Configure the network parameters of the oscilloscope according to "To
Configure the LAN Interface".
3. Search for device resources
Start up Ultra Sigma and click
displayed. Click
instrument resources currently connected to the LAN; the resources found are
displayed at the right of the window (as shown in Figure (b)). Click
to add the resource.
Note: If you want to remove the unwanted resource, click the resource name to
select it and then click
14-6
. The window as shown in figure (a) is
in the window and the software will search for the
(a)
(b)
.
Chapter 14 Remote Control
DS4000E User's Guide