Record - Rigol DS4024E User Manual

RIGOL
Note: The X-Y cursor mode is only available when the horizontal time base
mode is X-Y.
Display: press this key to enter the display setting menu. You can set the

waveform display type, persistence time, waveform intensity, screen grid type,
grid brightness and menu display time.
Utility: press this key to enter the system auxiliary function setting menu. You

can set the system-related functions and parameters, such as the I/O setting,
sound and language. The oscilloscope also supports some advanced functions,
such as the pass/fail test and print setting.
Record: press this key to enter the waveform recording menu. You can select

the desired waveform recording mode and set the related parameters.
Help: press this key to open the help interface. For the detailed information,

please refer to the introduction in "To Use the Built-in Help System".

Record

Stop Play/Pause Record
Record: press this key to start recording the waveform. The backlight is

illuminated in red and flashes. Besides, the backlight will also be illuminated in
red and flashes when the open mode (record constant on) is enabled until you
press RUN/STOP to stop the waveform recording.
Stop: press this key to stop the waveform recording or waveform playback. The

backlight is illuminated in orange. Besides, the backlight will also be illuminated
in orange when the waveform recording or waveform playback finishes.
Play/Pause: when the waveform recording is stopped or when the waveform

palyback is stopped or paused, pressing this key to start playing back the
waveform; the backlight is illuminated in yellow and flashes. Pressing this key
again to pause the playback; the backlight is illuminated in yellow.
1-20
Chapter 1 Quick Start
DS4000E User's Guide