To Perform External Storage And Recall - Rigol DS4024E User Manual

Chapter 12 Store and Recall
knob
the knob to open the local disk recall interface.
3) Turn the multi-function knob
becomes available and press the softkey to recall the file selected.
Tip
Pressing REF  Import can enter the disk management interface of
1.
reference waveform file recall.
2. Pressing Utility  Pass/Fail  Load can enter the disk management
interface of pass/fail test mask file recall.

To Perform External Storage and Recall

Before performing external storage and recall, make sure that the USB storage
device is connected correctly.
The external memory supports the storage of all the types of files in Storage as well
as the recall of "Traces", "Waveform" and "Setups" files. But, the recall of "Picture"
and "CSV" files is not supported. In the following setion, the external storage and
recall methods and procedures are introduced in details.
1. Save the specified type of file in the external USB storage device (take
CSV storage as an example)
1) Connect the signal to the oscilloscope and obtain stable display.
2) Press Storage  Storage; turn the multi-function knob
"CSV" and press the knob. You can also press Storage continuously to
switch to "CSV".
3) Set the CSV storage parameters.
Press DataDepth to select "Displayed" or "Maximum".
a.
When "Maximum" is selected, press Channel; turn the multi-function
knob
press the knob or press Channel to switch the waveform data storage
state of the channel (channel group). The waveform data storage state
of the channel (channel group) is displayed at the front of the channel
(channel group) name;
channel;
DS4000E User's Guide
to select "Local Disk" (the characters turn green) and press down
to select the desired channel (CH1, CH2, CH3, CH4) and
denotes not saving the waveform data of the channel.
to select the file to be recall; Load
denotes saving the waveform data of the
RIGOL
to select
12-7