To Make All Measurement - Rigol DS4024E User Manual

RIGOL

To Make All Measurement

The all measurement function can measure all the time, voltage and area parameters
(21 items in total, please refer to Table 6-5) of the waveform(s) of the specified
channel(s) (one or more of the waveforms of CH1 to CH4 and MATH) and display the
measurement results on the screen.
Note:
When the all measurement function is turned on, the one-key measurement

function is still valid (refer to "To Make One-key Measurement").
"To Clear the Measurement" operation will not clear the results of all

measurement.
1. Select channel(s) for "All Measurement"
Press Measure  Measure Source, turn the multi-function knob
the specified channel (CH1 to CH4 or MATH) and press the knob or press
Measure Source to switch the selection status of the channel. The selection
status of the channel is displayed in front of the channel name;
performing the all measurement function on the channel;
perform the all measurement function on the channel. One or more of CH1 to
CH4 and MATH can be selected at the same time.
2. Turn on the all measurement function
Press Display All to turn on the all measurement function. The oscilloscope will
measure all the time, voltage and area parameters (21 items in total, please
refer to Table 6-5) of all the source channels currently selected and display the
measurement results on the screen.
Note:
When multiple "All Measurement" source channels are selected at the same

time, the measurement results (the measurement results are in the same
color as the channel) of the channels selected will be displayed on the
screen from top to bottom in CH1, CH2, CH3, CH4 and MATH order.
If the measurement result is displayed as "*****", there is no signal input

into the current measurement source or the measurement result is out of
the valid range (too large or too small).
6-34
Chapter 6 Operations and Measurements
denotes do not
DS4000E User's Guide
to select
denotes