Important Information - Gazer F715 User Manual

ENG
• Do not insert or remove the SD card when the power is on – this can lead
to dash cam malfunction. Prior to inserting or removing the memory card,
make sure that the dash cam is switched off or that its power has been
turned off for at least 30 seconds and its indicators went dark at least
10 seconds ago.
• Set the correct time and date before using the product.
• Observe at least half a second time interval while pressing control buttons.
Otherwise you may need to reboot the dash cam by unplugging the power
cable.
• Do not turn off the power for at least 20 seconds after the power cable is
connected. This is necessary to ensure the dash cam's normal operation.
• If after starting the engine (with the power cable connected) the dash cam
fails to switch to the recording mode automatically, turn ACC power off for
10 seconds and then turn it back on.
• To install and connect the dash cam without voiding your vehicle warranty,
please contact an authorized service station.
• Loop recording of G-sensor write-protected files is limited to 30% of the
total storage space on the memory card. Files protected from overwriting
by pressing a special button use the same storage space but cannot be
overwritten. It is recommended to format the memory card every once in
a while or backup «accident» footage to a PC so that video recording never
stops due to insufficient space.
6

Important information

Caution!