Important Information - Gazer H714 User Manual

ENG
1.
Do not insert or remove the SD card when the device is on -
this can lead to MVR malfunction.
Wait for 30 seconds after MVR shutdown, make sure that all
the lights are off for at least 10 seconds, and only then safely
remove the memory card.
Set the correct time and date before using the device. The
2.
MVR may not record in case these settings were entered
incorrectly.
Use at least 0.5 seconds time interval while pressing control
buttons, otherwise you may need to unplug the MVR power
3.
supply cable to reboot the system.
Do not turn off the power for at least 20 seconds after the
power supply cable is connected. This is necessary to help the
4. MVR function correctly.
If after starting the car (when the power supply cable is
connected to the MVR), the device fails to switch to the
recording mode automatically, simply turn off the ACC power
5.
for ten seconds and then try again.
Please consult your car service station for device installation
assistance to prevent the violation of your car warranty rules
and conditions.
6.
Files protected from overwriting by the G-sensor are recorded
in a loop taking up 30% of the total storage space.
Files protected by pressing a special button use the same
storage space but cannot be overwritten.
It is strongly recommended to back up the recordings stored
on your memory card to a computer or other media to prevent
data loss (this happens when the memory card is full).
6

Important information

Warning!