Preparing The Dash Cam - Gazer F715 User Manual

Preparing the dash cam

One needs to preconfigure the dash cam before using it. By default (factory
ENG
settings), all main parameters are set to optimal values. Nonetheless, one still
needs to set the exact time and date. This is necessary for proper operation of
the recording mode and further analysis of recorded video clips.
For correct adjustment of settings, we recommend connecting the dash cam
to a display. You can use Gazer monitor, Gazer rear view mirror with a built-in
monitor, or any other display with a composite video input.
Before inserting a memory card into the slot, make sure that the dash cam is
turned off and all indicators are inactive.
The memory card must be inserted with contacts facing the status indicators.
Connecting with a display
Connect the dash cam to a display and plug in the power supply.
To access the dash cam settings menu, you first need to stop the recording by
pressing • REC (the recording stops with some delay because the device needs
to close and save the file with the last video clip) and then press and hold RIGHT
for 3 seconds.
Use LEFT and RIGHT, to navigate the settings menu, press OK, to go to the
submenu and select parameters, long press RIGHT to exit from the menu.
Viewing records
You can view recorded video clips from the dash cam menu. You can also remove
the memory card from the dash cam and view the recordings on your PC.
Viewing from dash cam menu
Connect the dash cam to a monitor or a TV set using the RCA composite video
output. Plug in the power supply.
Stop the current recording by pressing • REC, then switch to «view» mode by
short pressing RIGHT.
Use LEFT and RIGHT to navigate your video archive. Pressing OK will start or
stop playback. When you finish viewing, do not forget to resume the recording
by pressing • REC.
15