Important Information 5 Eng - Gazer F525 User Manual

• Do not insert or remove the SD card when the device is
connected to a power supply or working with an external power
unit. This can lead to the MVR malfunction. Wait for 30 seconds
after the MVR shutdown, make sure that all the lights are off for
at least 10 seconds, and only then safely remove the memory
card.
• Set the correct time and date before using the device. The MVR
may not record in case these settings were entered incorrectly.
• Use at least 0.5 seconds time interval while pressing control
buttons, otherwise you may need to remove the battery from
the device in order to reboot the system.
• Carefully connect the power supply cable to the device. MVR
power supply cable should not be confused with the radar
detector or navigator power supply cables (those may have
voltage of +12V). A wrong connection may cause MVR failure.
• Do not turn off the power for at least 20 seconds after the
power supply cable is connected. This is necessary to help the
built-in battery function correctly.
• If after you have started the car (when the power supply cable
is connected to the MVR), the device failed to switch to the
recording mode automatically, simply unplug the power supply
cable for ten seconds and then try again.
• Use the restart option (by removing the battery from the MVR,
when the power supply cable is disconnected) in the following
cases:
• Power indicator is not on when the power supply cable is
connected;
• The device does not switch from the standby to the recording
or control mode;
• The device fails to function properly.
• To restart the MVR, turn the power off, remove the battery
cover (p. 9, c. 7) and carefully remove the battery from the slot
for at least 5 seconds. Then put the battery back, close the
cover and reconnect the power supply cable.
Important information
Warning!
ENG
5