Table of Contents
Advertisement
Menu (Thick.)
UTIL
AUTO FIND
(UTILITIES)
SCAN MODE
ALARM
ALARM HIGH
ALARM LOW
DIFFERENTIAL
GAUGE
XFER
BACKUP
(TRANSFER)
SETUPS
RESTORE
SETUPS
BACKUP DATA
RESTORE DATA
ABOUT
Function
Automatically
measurement is out of the viewable display area.
Enables a high speed scan mode that increases the overall
sample rate from 65 to 200 measurements per second,
depending on the current measurement mode used.
Toggles alarm mode ON, OFF, or AUDIBLE.
Sets the HI limit parameter. If the measurement exceeds
this value, a red light will illuminate and the alarm will
sound.
Sets the LOW limit parameter. If the measurement falls
below this value, a red light will illuminate and the alarm will
sound.
Sets a nominal value and your gauge will display +/- the dif-
ference from this nominal value.
Set gauge type; THICKNESS GAUGE, FLAW DETECTOR
or REQUEST.
When set to REQUEST, the gauge will ask which mode is
required whenever it is switched on.
Allows you to backup the setups currently stored in your
gauge to a computer via the RS232 port.
Allows you to restore setups saved on a computer to your
gauge via the RS232 port.
Allows you to backup grids or sequential log files stored in
your gauge to a computer via the RS232 port.
Allows you to restore grids or sequential log files saved on
a computer to your gauge via the RS232 port.
Provides Elcometer NDT contact information and your
gauge software version.
Refer to the help section of your gauge NDT Link software
for a complete electronic manual covering data transfer.
Description
locates
the
detection
point
if
the
62
Advertisement
Table of Contents
