Reobserved Route Merge - Topcon DL-501 Instruction Manual

14.4

Reobserved Route Merge

This function merges an existing route (the base route) with a reobserved section of that same route
(the reobserved route).
a1
Base route
Merged route
a1
As shown above, the merged route uses the reobs. start point id from the base route and the reobs.
end point id from the reobserved route.

• With the exception of route ID and memo data, all route settings for a reobserved route shall be
identical to the route settings for the base route being reobserved. However, start bench mark
elevation and end bench mark elevation shall be automatically set to 0.0000m, and start bench
mark/end bench mark IDs shall be left blank (NULL). These settings cannot be changed.
PROCEDURE Selecting a route to reobserve
1. Select "Management" in <Menu>.
2. Select "Route" in <Management menu>.
Reobs. start pt
a2 a3
b1
b2
a2
b2
14. CALCULATION FUNCTIONS
Reobs. end pt
a4 a5
b4
Reobserved route
b3
b4
b3
M e n u
1 . M e a s
2 . M a n a g e m e n t
3 . C o n f i g
4 . C a l c u l a t i o n
M a n a g e m e n t m e n u
1 . J O B
2 . R o u t e
3 . K n o w n p o i n t d a t a
4 . S i m p l e m e a s . d a t a
a6
a6
69