Changing The Settings; Observation Conditions - Topcon DL-501 Instruction Manual

19.CHANGING THE SETTINGS

This section explains the contents of parameter settings, how to change these settings, and how to
restore default settings.
Each item can be changed to meet your measurement requirements.
C o n f i g m e n u
1 . O b s . c o n d i t i o n
2 . I n s t r . c o n f i g
3 . C o m m s s e t u p
4 . T i l t o f f s e t
5 . U n i t
Instrument constants are explained in a different chapter.

"21.2 Tilt Sensor", "21.3 Adjusting the Reticle"
19.1

Observation Conditions

M e a s m o d e
R e c c o n d .
S D m i r r o r i n g : O f f
H t r e s o .
D i s t r e s o .
Items set and options (*: Factory setting)
Measurement mode (Meas mode):
AVG times (only displayed when:
"Average" selected above)
Rec cond.:
SD mirroring (only displayed when:
"Yes" selected above)
Height resolution (Ht. reso.):
Distance resolution (Dist reso.):
Earth curvature and refraction correction (C&R):
Auto Focus setting. (A.F.setting):
Tilt warning (Tilt warn):

• "Rec cond." cannot be changed for a JOB already containing route data.

• There is no "A.F. setting" for the DL-501 Standard.
: S i n g l e
: Y e s
: 0 . 0 1 m m
: 0 . 0 0 1 m
Single*, Repeat, Average, Rapid
1 to 20
Yes*, No
On/Off*
0.01mm/0.0001ft*, 0.1mm/0.001ft, 1mm/0.01ft
0.001m/0.01ft*, 0.01m/0.1ft, 0.1m/1ft
No*, K=0.142, K=0.20
Yes*, No
Yes*, No
C o n f i g m e n u
6 . D a t e a n d t i m e
C & R
A . F . s e t t i n g
T i l t w a r n
: N o
: Y e s
: Y e s
95