Topcon DL-501 Instruction Manual page 61

• Press [OK] in the screen shown at right to
record results and return to the previous
screen.
Measurements of subsequent IS points can
be performed from this screen.
Press {ESC} to exit IS measurement.
•
When height difference measurement in the
first section is complete, press [S-O] in the
second page to perform setting-out.
16. Set up the DL in the center of the next section.
17. Repeat steps 8 to 15 to measure the
subsequent sections. The foresight for the
previous section becomes the backsight for
the current section.
• Press [FIXEDP] in the screen of step 15 to
set up a fixed point. Input a temperature and
memo and press [OK] to proceed the next
screen.
Press [END] then [YES] in the screen shown
at right to end height difference measurement
and return to <Height dif. meas menu>.
18. Check the results for the final section.
Press [END] in the results screen for the final
section.
19. Set temperature and enter a memo.
Press [OK] to record results and end height
difference measurement.
<Height dif. meas menu> is restored.
12. HEIGHT DIFFERENCE MEASUREMENT
I S
R o u t e 0 1 - A 1 - 0 0 0 2
R h 1 . 3 4 5 6 m
H d 3 0 . 1 2 3
Z 2 0 . 2 2 2 2 m
d 6 9 . 0 2 3 m
D 6 9 . 0 2 3 m
h 0 . 3 3 3 2
H 0 . 3 3 3 2
Z 2 0 . 3 3 3 2
S - O
F i x e d p t N o . 0 0 0 3
F e b / 1 7 / 2 0 0 9 1 0 : 3 3 : 2 8
T e m p :
M e m o
:
T h e m e a s u r e m e n t
o f t h e r o u t e
i s e n d e d .
d 1 2 3 . 4 5 6
D 5 6 7 . 8 9 0
h 1 . 2 3 4 5 m
H 4 . 5 6 7 8 m
Z 2 4 . 5 6 7 8 m
FIXEDP
F e b / 1 7 / 2 0 0 9 1 2 : 2 3 : 5 8
T e m p :
M e m o
:
M e a s . i s e n d e d .
G o
S
m
O K
m
m
m
P 2
1
C
E N D O K
N O Y E S
m
m
E N D O K
1 5 . 0 C
1
O K
53