Topcon DL-501 Instruction Manual page 67

Align the cursor with the route you wish to use
as the go run and press {
selection> is restored.
• Press [TOP] to move to the first route on the
first page.
• Press [LAST] to move to the last route on the
last page.
Repeat the above to select the route you wish
to use as the return run.
4. Check settings, then press [CALC]. Double-
run discrepancy and relative height results are
displayed.
• Press [ADJUST] to distribute discrepancy
among points.
•
Press [FIXEDP] to display results for fixed
points. Press [NEXT]/[PREV] to display
results for the next/previous fixed point. Press
{ESC} to return to <Dble-run discrepancy>.

• Both the go run and return run must contain
the same number of fixed points.
• The display range for dH results is -99.99 to
99.99 (mm). Results falling below/exceeding
this range will be displayed as -99.99 or 99.99
respectively.
5. Press {ESC} to return to <Calculation menu>.

}. <Route
14. CALCULATION FUNCTIONS
* R 0 0 1
R 0 0 2
T O P
D b l e - r u n d i s c r e p a n c y
d H
R e l a t i v e h e i g h t
G o
R e t u r n
ADJUST FIXEDP
F i x e d p t . N o . 0 0 0 1
d H
R e l a t i v e h e i g h t
G o
R e t u r n
NEXT
L A S T
- 0 . 6 0 m m
1 2 . 4 3 7 0 8 m
- 1 2 . 4 3 6 4 8 m
O K
- 0 . 3 0 m m
4 . 3 1 2 8 0 m
- 4 . 3 1 2 5 6 m
59