Table of Contents
Advertisement
Installation
Install Wall Switch Kit (required)
The wall switch kit is provided with this appliance. It is
connected to the receiver in the fi replace. The receiver
is located left of the control valve under the fi rebox.
Decide where the switch is to be installed. Install an
electrical outlet box or mud ring as required (not
supplied).
1. Thread the switch wire through an access hole in
the appliance. DO NOT run the wire over top of the
appliance.
2. Pull out the receiver. You can remove the ignition
wire to improve access.
3. Take the switch wire and
plug it into the receiver's
connection slot as in-
dicated (the other slot
should already be fi t-
ted with the valve's wire
harness connector). See
diagrams below.
IMPOR-
TANT: The connection
can only be done one
way. Do not force it or
damage the pins!
4. On the outside of the fi replace, run the switch wire
into the outlet box. Use insulated type staples to
secure the wiring to framing.
5. Plug the wire into the switch plate and to the outlet
box.
6. Reconnect the ignition wire to the receiver if it was
previously removed.
IMPORTANT: Make sure the ignition wire DOES
NOT TOUCH the receiver's antenna.
IMPORTANT: The connection
can only be done one way.
Do not force it or damage
the pins on the receiver box!
7. Insert 4 AA
alkaline
8. Connect the battery holder wire to the receiver.
9. Connect the wire to the battery holder.
10. Test the operation of the wall switch—see Appendix C.
11. Fix the wall cover plate to the outlet box.
12. Replace the receiver in its position and as well as the
antenna if deployed.
IMPORTANT: The antenna MUST NOT TOUCH the
ignition wire.
13.
Place the battery holder near the receiver. Keep
the wires tidy to prevent them from touching the
underside of the burner.
Caution
DO NOT PUT BATTERIES IN THE BATTERY HOLDER
until the wires are connected to the burner
control unit as short-circuit could result in the
destruction of the electrical components.
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery
holder or the handset! This could cause a short
circuit to the receiver.
Do not run the switch wire over the top of the
firebox. Route the wire so it does not contact the
firebox.
To avoid short-circuit to the receiver, position the
antenna so that it DOES NOT TOUCH the ignition
wire.
Wall Switch Kit
batteries in the battery holder.
55
Advertisement
Table of Contents
