Selected Card Operations - Honeywell 5701 Operating Instructions Manual

MAN0443.P65 Issue 13 Aug 04
05701-M-5001 A02279
CHAPTER 7 - ENGINEER'S OPERATING
INSTRUCTIONS
4.

SELECTED CARD OPERATIONS

The operation to be carried out on the selected control card is chosen by
pushing one of the following Engineering Card control push-buttons:
Once an operation has been selected, there are four control push-buttons
which may be used to manipulate the operation as required. These are:
a. The up push-button, which may be used to raise the selected
control card indicted value. If held in the operated position, the
display will be increased by one unit every 0.5 seconds.
b. The down push-button, which may be used to lower the selected
control card indicated value. If held in the operated position, the
display will be decreased by one unit every 0.5 seconds.
c. The accept push-button, which may be used to accept the selected
control card displayed value and store this permanently as part
of the configuration. Returns the control card to the selected
mode.
d. The reject push-button, which may be used to reject the selected
control card displayed value and return to the previous set value.
Returns the control card to the selected mode.
7 - 6
5701 Control System