Honeywell 5701 Operating Instructions Manual page 138

MAN0443.P65 Issue 13 Aug 04
05701-M-5001 A02279
CHAPTER 4 - INSTALLATION INSTRUCTIONS
(5) Insert the module, with the same orientation as the already fitted
module, into the vacant position inside the 50W Sub Unit and
secure using the washers and long nuts retained in Step (3).
(6) Connect the 50W Sub Unit second ac input and 24V dc output
cable connectors to the ac input terminal CN1 and dc output
terminal CN2 respectively on the added 50W Switched Mode
Module as shown below:
CN2
DC Output
(7) Refit the top cover.
18.3 16-Way AC to DC Power Supply Unit Upgrade to 150W or
200W
To upgrade the 16-Way AC to DC Power Supply Unit to 150W or
200W proceed as follows:
(1) Fit a second 50W Sub unit, containing a 50W Switched Mode
Module, to the 16-way AC to DC Power Supply Unit front panel
using the fixings supplied.
(2) When an upgrade to 200W is required, fit a further 50W Switched
Mode Module into the new 50W Sub unit as indicated in Section 17.2.
4 - 75
5701 Control System
CN1
AC Input