Rack Installation - Honeywell 5701 Operating Instructions Manual

MAN0443.P65 Issue 13 Aug 04
05701-M-5001 A02279
CHAPTER 4 - INSTALLATION INSTRUCTIONS
10.

RACK INSTALLATION

The 16-way 3U high rear access and 6U high front access racks are
suitable for mounting in standard 19" (483mm) wide Mounting Frames.
These are fitted as follows:
(1) Insert the rack into the 19" Mounting Frame and secure using M6 or
similar bolts through the four mounting holes located on the front
flange plates.
(2) Ensure adequate support at the rear of rear access racks.
(3) Prepare and connect the cable ends to Field Interface and Relay
Card terminals. For terminal identification see Chapter 2. Where
possible keep sensor cables separate from the other wiring.
(4) Ensure that the rack is properly earthed by connecting a suitable
earth cable to the earth stud located at the rear of the rack.
Do not apply power to the System 57 until the commissioning
procedure has been read and understood. See Chapter 5.
CAUTION
4 - 18
5701 Control System