Extraction Slot; Display Label And Cover - Honeywell 5701 Operating Instructions Manual

MAN0443.P65 Issue 13 Aug 04
05701-M-5001 A02279
CHAPTER 3 CONTROLS AND FACILITIES
2.5

Extraction Slot

An extraction tool is used in conjunction with the extraction slot, just below
the select push-button, to remove the card from the rack. The extraction
tool is provided as part of the Key Kit (05701-A-0550) supplied with each
rack assembly.
The card is removed by first unscrewing the two card securing screws,
one at the top of the card and the other at the bottom of the card, and then
hooking the extraction tool into the extraction slot and then gently pulling
the card out of the rack.
2.6

Display Label and Cover

A clear perspex cover clips to the front panel and retains the label which
provides identification of the control card type, sensor scale, LED and
push-button functions.
Two different label colours are used:
a. Grey/Blue -
b. Violet -
The perspex cover is removed by first
removing the control card from the rack
and then locating a small hole on the
inside of the front panel just above the
LCD display. A blunt object, such as a
screwdriver, is then pushed through the
hole to unclip the perspex cover.
A small recess in the perspex cover
allows a label to be inserted to indicate
the channel tag name or gas type.
Control cards fitted with Catalytic Sensor Drive
Modules.
Control cards fitted with 4 - 20mA Sensor Drive
Modules.
3 - 13
5701 Control System
Extraction
Hole