Setting The Bobbin - Brother 882-W73 Operation Manual

WINDING/INSTALLING THE BOBBIN
 Using the Spool Stand (Included with Some
Models)
To wind thread on the bobbin while the spool stand is
installed, pass the thread from the spool through the
thread guide on the telescopic thread guide, and then
wind the bobbin according to steps
"Using the Supplemental Spool Pin"on page 31 to
page 33.
IMPORTANT
• When winding thread on the bobbin, do not
cross the bobbin winding thread with the
upper thread in the thread guides.
34

Setting the Bobbin

e j
through of
a
b
c
d
e
CAUTION
• Use a bobbin that has been correctly wound
with thread, otherwise the thread tension may
be incorrect and the needle may break,
causing injuries.
• Before inserting or changing the bobbin, be
sure to touch in the LCD to lock all keys
and buttons. Otherwise injuries may occur if
the "Start/Stop" button or any other button is
pressed and the machine starts sewing.
Touch to lock all keys and buttons and raise the
presser foot.
* If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, touch
to continue.
Slide the bobbin cover latch to the right.
a
1 Bobbin cover
2 Latch
 The bobbin cover opens.
Remove the bobbin cover.
Hold the bobbin with your right hand and hold the end
of the thread with your left hand.
Set the bobbin in the bobbin case so that the thread
unwinds to the left.