Adjusting The Desk Height With Operating Panel Memory - Steelcase Migration Bench User Manual

Operation and settings

Adjusting the desk height with operating panel Memory

Before adjusting the height of the desk, ensure the following:

The display of the operating panel does not show an error message (see Error messages on the display
of operating panel Memory).

No one is in the lifting range. No objects (such as open doors or windows) are in or protrude into the lifting
range.

No objects should be in the movement area of the lift column.

No one should be on the desk.

The maximum permissible load capacity of the desk is not exceeded (see Technical data).

No heavy loads are on the desk top. Heavy loads make the height adjustment more difficult.

The desktop must be horizontal. If the floor is uneven, align the desktop with the adjusting screws on the
feet.
Ensure that the connecting cables of devices on the desk are long enough.
A lift movement takes place only

As long as you press the appropriate button,

As long as the maximum load (approx. 50 kg) is not exceeded.
The desk starts moving!
CAUTION! The desk moves at a speed of approx. 4 cm/s.
NOTICE
Damage to the desktop is possible!
If the desktop is moving on one side or unevenly:



Migration Manual -en- 2018
 Press the "Up" or "Down" button.
Release the button immediately to stop the movement.
Determine the cause using the fault-finding table (see Error messages on
the display of operating panel Memory).
Consult a service technician if necessary.
Page 25 of 35