Manuel Reset On Operating Panel Up/Down - Steelcase Migration Bench User Manual

Operation and settings
NOTICE
Risk of damaging the operating panel!

Manuel reset on operating panel up/down

You must carry out an end position calibration of the lowest desktop position:

Before first use.

When the actual desktop position no longer matches the displayed desktop position.

When a previously configured motor controller is used in a different electrically height adjustable workstation
of the same design.
WARNING
Danger of crushing and shearing!
During reset and end position calibration, the software-assisted stop device is
not active.

Releasing the button before completing the process interrupts the reset and requires a restart.
Migration Manual -en- 2018
Do not lean on the operating panel.

Do not place any objects on the operating panel.

Do not pour liquids over the control panel.

Keep sufficient distance from the desk during reset.
 Press and hold the "Down" button until the lower end position (programmed
desktop position) is reached.
 Release the "Down" button.
 Again, press and hold the "Down" button for approx. 5 s.

The desktop moves to the lower end position.
 Release the "Down" button. The system is now ready for operation.
Page 22 of 35