Honda Metropolitan CHF50 Service Manual page 231

FRONT WHEEL/BRAKE/SUSPENSION/STEERING
If the handlebar grips were removed, apply Honda
Bond A or Honda Hand Grip Cement (U.S.A. only) to
the inside of the grip and to the clean surfaces of the
right and left handlebar.
Allow the adhesive Wait 3 - 5 minutes and install the grip.
to dry for 7 hour Rotate the grip for even application of the adhesive.
before using.
Install the left handlebar switch housing aligning its
locating pin with the hole in the handlebar.
Install the screws and tighten the forward screw
first, then the rear screw.
Apply grease to the sliding surface of the throttle
pipe.
Connect the throttle cable end to the throttle pipe.
Install the throttle pipe into the handlebar.
Install the right handlebar switch/throttle housing
by aligning its locating pin with the hole in the han-
dlebar.
13-19