Honda Metropolitan CHF50 Service Manual page 103

FUEL SYSTEM
Coat a new O-ring with oil and install it to the intake
manifold groove.
Install the intake manifold and tighten the bolts.
Install the insulator while aligning the groove in the
insulator with the tab on the intake manifold.
Tighten the insulator band screw.
Install the carburetor body into the insulator and the
connecting hose.
Align the tab of the carburetor and the tab of the
intake manifold and adjust the level position of the
carburetor.
'02 - '03 model Tighten the band screws securely as shown.
5± 1 mm (0.2 ±0.04 in)
After '03: V.I.NAfter Tighten the band screws to the specified torque.
5018998:
T 0 R Q U E
. 3
Q N
.
m
,
0 3Q k g f m 2 2
|
b f
.
f t )
Connect the water hose into the cylinder.
Connect the throttle cable to the throttle drum and
install them in the cable holder.
Loosely tighten the throttle cable adjusting nuts.
Connect the followings:
- Throttle position sensor 3P connector
- SE valve 2P connector
SE VALVE 2P CONNECTOR
I THROTTLE POSITION
I THROTTLE CABLE \ SENSOR 3P CONNECTOR
5-17