Install Windows Server 2008 R2 Manually; Preparation Before Installation - Inspur NF5270M3 User Manual

After driver make completes, a window will pop up, indicating driver make is
done, click <OK> to complete driver make.
● Notes for Loading Driver Using Inspur Drive U Disk under Windows
System
During installation of Windows operation system, if you load hard disk controller
driver using Inspur drive U disk, enter disk partition interface, Inspur drive U disk will
occupy a disk, if the hard disk is not partitioned, U disk will occupy disk C:, otherwise,
U disk will occupy another disk (Please distinguish according to actual hard disk
partition).
If there's any other partition on hard disk, it is required to delete all partitions on
hard disk, and create a new partition on hard disk, U disk will not occupy any disk by
then.
If hard disk is not partitioned, it is required to create 1 disk partition on
unpartitioned space, and delete this new disk partition, U disk will not occupy any disk
by then, and then create a disk partition according to actual needs, complete installation
of operation system according to prompts.
Note: Make sure to distinguish U disk and hard disk, do not delete or format U
.
disk

5.2 Install Windows Server 2008 R2 Manually

5.2.1 Preparation before Installation

● Windows Server 2008 installation DVD
● Inspur Driver CD
● Hard disk controller drive fl oppy disk (external LSI 2108 RAID confi gured for
Windows Server 2008 R2 installation does not need any driver)
● If a USB fl oppy disk is used for the above drivers, please make the driver into a
fl oppy disk; if an Inspur drive U disk is used, please make the driver into Inspur drive
U disk; if a normal drive U disk is used, during driver make, enter normal U disk and
Chapter Five Operation System Installation Chapter Five Operation System Installation
33