Mainboard Jumper Setting; Open Case Top Panel; Jumper Setting Figure - Inspur NF5270M3 User Manual

guide system from equipment selected.

3.2 Mainboard Jumper Setting

Mainboard jumper setting is to short circuit two pins of the jumper to change
interface function, see the following fi gure, so as to adjust mainboard functions.

3.2.1 Open Case Top Panel

If the following operation is required, please obtain authorization of Inspur Group
Co., Ltd. fi rst, open top panel of the case, detailed steps are as follows:
1. Shut down the system (disconnect AC power cable);
2. Loosen two bolts at the back of case top panel;
3. Vertically press down card slots on case top panel with two thumbs, and push
top panel towards back of the machine.
4. Remove case top panel.
Chapter Three System Setup Chapter Three System Setup

Jumper Setting Figure

Open Case Top Panel
23